Operation of the Manual Transmission CAR- CHERY QQ

Operation of the Manual Transmission CAR- CHERY QQ
Step down the clutch completely and move the shift joystick, and loose the clutch after shift.
¡INotice
Do not shift in driving. When the car stops completely, back-up shift can be used to avoid any damage to the transmission. Do not lay your foot on the clutch panel to avoid any damage to the clutch.
Operation procedure to start a engine with AMT transmission ()
Keep the transmission gear position on the N gear, 1st or 2nd
Turn the key to the position ¡§III¡¨, and DO NOT step on the accelerator pedal to start the engine. After the engine starts, release the key. If the engine fails to start, repeat the procedure above. gear before the engine starts. DO NOT step on the brake to start the engine when the transmission is placed in N gear position, otherwise the engine fails to start.
! CAUTION: The starter can¡¦t operate for above 10 s every time, otherwise, it may damage the starter. If the engine still fails to start, wait for 15 s and then have a try (for the vehicle equipped with the automatic transmission, turn the ignition switch, wait for 10 s and then have a try)
Operation procedure of AMT transmission ()
R = Reverse
N = Neutral
Manual gearshift mode
+ = Upshift
- = Downshift
1. Shift to the R position only after the selector lever is in the N position. And there is a instrument alarm sound to give a prompt;
Neutral Position
Start and Operation
36
2. To enter the automatic gearshift mode, press the AUTO key to enter the mode, and press the AUTO key again to enter the manual gearshift mode;
3. In the case of manual gearshift mode, push the selector lever towards the + direction, and then increase the transmission up to adjacent upper gear position; and push the lever towards the ¡V direction, and then reduce the transmission down to the adjacent lower gear position¡F
4. In the case of manual mode, the upshift can be conducted under any speed of the vehicle; and the downshift can be implemented only when the speed drop is in allowable range.
! CAUTION: In the case of emergency braking, the automatic gear position drop function can be carried out either in the AUTO mode or in the MANUAL mode, without the manual gear drop operation
Start the vehicle in case of manual transmission
After the engine starts, shift to the proper gear position, release the brake, and slightly step on the accelerator pedal to make the vehicle gradually enter into the travel state. If it is difficult to shift the gear, slowly step on the accelerator pedal, and shift to the proper gear position again.
! CAUTION:¡GWhen the vehicle starts on a slope, the hand brake must be pulled before the vehicle starts. Slightly step on the accelerator pedal, release the hand brake at the same time, and ensure that the engine bonnet is fully closed, otherwise, it is difficult to start the vehicle.
ƒÞ Start the vehicle in case of AMT transmission ()
After the engine starts, shift to the proper gear position. Regardless of the AUTO or Manual mode, the vehicle can start only after manually shifting to the 1st gear position. In case of the idle speed, shift to the 2nd gear or below. After shifting to the proper gear position, release the brake, step on the accelerator pedal and then enable the vehicle to enter the travel state. If the accelerator pedal isn¡¦t stepped on, although the proper gear position is shifted, the vehicle can¡¦t travel yet.